Here are some Spotted Turtle egg incubation tips I had posted some weeks ago in a previous post. They will prob help you out as well. Also, hopefully you are looking for an Adult Male Wood that is part of someone's LTC private collection or captive bred. Watch out for any responses of someone trying to get you an Adult Male Wood that they can not give proof of its origin, as Wood's are protected throughout their range.

Spotted Turtle Egg Tips:
1. As soon as you dig the eggs out, mark the top of the egg with a pencil so you always know which is the top.
2. With a cotton ball (new one for each egg), carefully clean off each egg with a dilute chlorine solution. Mix 4 teaspoons of bleach with one gallon of clean water. Then use tissue paper to thoroughly dry off the egg. This process helps ward off any bacteria or fungus that might have been in the laying medium.
3. Place the eggs in tupperware containers with moist vermiculite/perlite. Equal parts of water to vermiculite/perlite by weight. You can use a basic pencil to puncture two holes in the lid of the container.
4. Spotted turtle eggs are temp dependent. 22.5-27 C (72.5-80.6 F) should result in males, while 30-30.5 C (86-87 F) should produce only females. I wouldn't recommend higher than 30.5 C due to chance of scute abnormalities. Temperatures between 27-30 degrees C may result in a mixed clutch, with more of one sex being produced depending on which sex dep. temp range you are closer to.
5. You shouldn't have to add any more water to the vermiculite/perlite during incubation, but do keep a open jar of water in the incubator to help maintain humidity.
6. Disturb the incubator as little as possible, but once to twice a week open, then close, the lid of eggs to "burp" them. It releases built up carbon dioxide and brings in fresh oxygen. Be mindful of the condensation on the inside of the lid when removing it so you don't accidently drench the eggs. You can just let the water run off back into the vermiculite.

Hope this helps,
-JG

[ Reply To This Message ] [ Subscribe to this Thread ] [ Show Entire Thread ]