hey erik, i don't have photos.
basically i made the top layer which consists of the 3 sections, then tacked screen on the bottom
then i cut the slider pieces which are the sides, middle, and back pieces and screwed those to the screen part ( covering the staples)
that's all you need for the bins, everything else you can just build around each shelf unit that basically just sets on a piece, and screws to it.
if you look at my photos you will see what i'm talking about.
just be sure to mount the screen to you can crease it up the front of the cage and put a trim piece over it. if you look real close you can see the screen coming up the front and going under the trim piece. this will make your clearance/gap absolutely nothing with the bin top actually in contact with the screen.

[ Show Entire Thread ]