Are you just trying to drill through the lids? I would place them on a hard surface and use a drill. (make sure whatever you set it on can be damaged because drill with go throuh!!)



If you are trying to put holes in the side just make sure to support the plastic and to not press to hard.



Good luck and keep us posted,



Chris
-----
Chris Smith

Contact

Captive Bred Herps

[ Hide Replies ]

• Putting holes in plastic enclosures - LauraV, Tue Mar 21 16:52:25 2006
• RE: Putting holes in plastic enclosures - CBH, Tue Mar 21 16:56:33 2006
• Actually neither , it's - LauraV, Tue Mar 21 17:04:39 2006
• RE: Actually neither , it's - CBH, Tue Mar 21 17:08:48 2006
• RE: Actually neither , it's - rainbowsrus, Tue Mar 21 17:09:27 2006
• It is feet... - LauraV, Tue Mar 21 17:14:38 2006
• Oops - LauraV, Tue Mar 21 17:16:09 2006
• Yeah, I was thinking - rainbowsrus, Wed Mar 22 00:11:39 2006
• RE: Actually neither , it's - Randall_Turner, Tue Mar 21 17:10:19 2006
• RE: Putting holes in plastic enclosures - rainbowsrus, Tue Mar 21 17:06:39 2006
• Thank you everyone. - LauraV, Tue Mar 21 17:18:30 2006
• RE: Putting holes in plastic enclosures - scaleman, Tue Mar 21 17:21:04 2006
• RE: Putting holes in plastic enclosures - ajfreptiles, Tue Mar 21 18:28:09 2006
• You are not kidding - LauraV, Tue Mar 21 18:42:25 2006
• RE: You are not kidding - ajfreptiles, Tue Mar 21 19:02:29 2006
• I usually heat up a metal rod - vcaruso15, Tue Mar 21 20:52:19 2006
• RE: a soldering iron... - cbreps, Wed Mar 22 08:38:38 2006