Posted by:
adamjeffery
at Wed Jul 19 19:33:08 2006 [ Email Message ] [ Show All Posts by adamjeffery ]
yeah its a pretty simple plan also, all i did was lay one sheet of melamine on the floor, then put my tubs on it and a thin piece of cardbord(1/8" and then another piece of melamine. i kept dpoing this until i had all the shelves i wanted. then i measured the sides and cut some 1x2's to fit and used a brad nailer to hold them in place. after everthing was square and level i pre drilled 2 holes per 1x2 and screwed them down. i made sure that i left 3.5 inches of space twords the back of the rack for flex watt(which i need to buy) and voila!! it cost about 40-50 bucks after all was said and done and only took about 30 inutes to assemble which includes predrilling.
adam
-----
hybrid breeders association
0.1. normal corn het hypo,anery
1.0. snow corn het hypo,anery,amel
1.0. amel corn unknown hets(4ft 8inch long)
1.0 sinacorn
1.1 kenyan sand boas
0.1 mbk
0.1 albino nelsons
0.2 normal leo geckos
1.0 blizzard leo gecko
0.0.1 snapping turtles
0.0.1 3 lined mud turtle
[ Hide Replies ]
|
RE: my newly built hatchling rack - adamjeffery, Wed Jul 19 19:33:08 2006