Posted by:
Steven_ucf
at Mon Oct 9 08:02:14 2006 [ Email Message ] [ Show All Posts by Steven_ucf ]
Hello,
I just bought a helix thermostat. I built my own rack system. But for my setup I just taped the probe on the heat tape; with a small piece of card board between the probe and the heat tape. You will want to use a thermometer on the heat tape side of your tub, because I found that the temperature was a little off from what the helix control said it was, and what it really was. Otherwise the directions on the helix control said you could make a dummy box and simulate the temps in the tubs.
Good Luck,
Steven
[ Hide Replies ]
|