I am in the process of building a new incubator out of a 102 qt marine cooler. Rubbermaid just came out with new cleartop containers that I was going to use until I read your post. The container is 12.35" x 8.65" x 3.6", I was going to use about 1" of verm/perl mix a little wetter that normal but use this very thin watertite foamlike sheet to put over the majority of the medium and lay the eggs directly on it and because the box seals I shouldnt loose much moisture at all. since the top is way thinner than the 1/4 plexiglass I was using, should I have a condensation problem, if the air temperature in the actual incubator is close enough to the internal temps in the container. I was going to start experimenting today.

[ Show Entire Thread ]