Posted by:
j3nnay
at Sun Dec 17 11:04:24 2006 [ Email Message ] [ Show All Posts by j3nnay ]
How do I get it to only heat up to 90 degrees?! I left it alone overnight, after twisting the little "adjustor screw" in the "decrease" direction as far as I could (easier to adjust the temperature up than down, right?), but when I woke up this morning it was at 105 degrees!
So, I tried twisting the screw the other way, thinking maybe that'd help...nope, temperature went right back up! (I left the top off for a while so that the temperature would go down to about 85 degrees)
Could I have put it together wrong? Am I not waiting long enough for things to stabilize? The instructions for chickens said wait half a day; it's been close to 24 hours and I can't figure this thing out!
The eggs are still in with the mother and the one on top that I can see has a long, shallow indent in it, is that normal?
My female just HAD to pick the week my brain would be the most fried!
~jenny
-----
1.2 normal ball pythons (Cindy, Darwin, and Periscope)
0.0.1 california kingsnake (Tetris)
0.2 rescue chinese water dragons
1.0 rex rat (Scurvy)
1.0 gerbil (Yerbul)
0.1 bunny (Spazz)
1.1 betta fishes (Vicious and Killer)
2.2 great danes (Shasta, Odysseus, Merlot, and Watson)
1.0 fat fuzzy mutt (Smokey)
1.1 cats (Thidwick and Turtle)
2.0 horses (Buddy and Sam)
1.0 goat (Billy Jack)
1.25 chickens (Ugly the rooster and his harem)
"God is a comedian playing to an audience too afraid to laugh." - Voltaire
[ Hide Replies ]
 Hovabator Question - j3nnay, Sun Dec 17 11:04:24 2006
|
