I wrote all of the previous post assuming that you would be using veneered plywood in the wood grain that you prefer. This is probably what I would use if I wanted to spend a bit more for a quality final product. I would likely use a two-part wood floor finish for lighter wood species. For darker species I would probably use a one-part varnish like Waterlox but would take caution to apply it correctly and make sure it offgassed completely before introducing the snakes.



If you found a melamine product with a faux wood grain that you liked then all of the previous post would not apply, other than the plastic flooring bit. Melamine is particle board that comes pre-finished with a plastic (melamine) veneer.



It has received a bad reputation in the reptile community. I believe much of this is due to the fact that many people just go to Home Depot or similar stores and buy the cheap melamine which just has a thin foil layer of plastic, not a thick thermofused layer like the higher quality melamine. I have made the same mistake.



The higher quality melamine should hold up fine in a cage like you describe, again especially since you will not be using misting systems or have live plants, etc. The floor, however, will still need a more durable layer to deal with water spills and the moisture held by substrate.



Melamine will be much cheaper and a lot less work then plywood. But plywood will be lighter, stronger and better looking.



If you decide to go with melamine, make sure to go to a cabinet supply shop or woodworking specialty store and get at product with at least a 100 weight melamine coating.
-----
Currently keeping a small collection of various Gonyosoma. Both G. janseni and G. oxycephala.

[ Show Entire Thread ]