My preffered ( notice I said "My" because what works for me may not work for you, either skill level or budget ) method for sealing wood is to use some type of epoxy, Bar top Epoxy or something close to it( West Systems would be an excellent place to start, or the more cost effective site, US Composites, http://www.uscomposites.com/epoxy.html specifically the Klear Koat Table epoxy but any of the thick epoxy's would work well...)



When and if you do buy the epoxy, do a small test pour, using the same technique as you would with the larger scale pour...



these intructions aren't meant to replace the manufacturers recommended methods, but here's the basics...



"Epoxy and You..."

- measure out desired amount using componet A into cup A

- measure out desired amount using componet B into cup B

- pour cup A into cup B

- Stir until clear (~ 3 - 4 minutes), ensuring you scrap sides to ensure proper mixing.

- Pour cup A/B into clean cup C

- Stir again (~ 3 - 4 minutes ), continuing to scrap sides while stiring.

- Pour onto clean, dust free, and dry surface ( dam the sides of your project to keep the epoxy where you want it )

- Do not scrap the remaining contents of Cup C onto your project, as there may still be unmixed componets and it will cause sticky/uncured spots to show up.

- use a torch or blow drier to remove any air bubbles

- keep project dust free for at least 8 hours while curing. ( I use a trash bag shroud to keep dust out, do not let it come in contact with the epoxy, it will cure to it, big mess!!)



Again... this is the basics, for instance, I didn't mention sealing coats and flood coats... but if you're interested... let me know...



hope this helps...



Karl

[ Show Entire Thread ]