These speaker boxes were recently removed from a local night club and found there way to my garage! They are built from 3/4 inch plywood and are glued as well as screwed together.They have trim already in place on the open front so have a finished look.They are already drilled in the back for power cords.Soooo,I think once I get the speaker mounts out and get them sealed at the joints and painted,all they will need is some tracks and sliding glass in the front and a vent over the hole in the back and a heat source and I have some pretty nice BCI enclosures! They are about 100lbs each so I am gonna stack them and put locking swivel casters on the bottom one.I wanted to hit you guys with a couple of questions and for opinions.Where do I go to buy the kinda trax I need for sliding glass?The paint on the outside is obviously black and kinda gloomy in my garage,it's shiny and looks like some kind of enamel??What would be my options as far as painting over it?I would LIKE to go over it with something lighter,but not if it's gonna take 20 damn coats,if it will, then I'll just repaint the outside black.Thoughts?? Suggestions??I'm open to anything at this point since the only thing I've done so far is put the casters on the bottom one.Oh and BTW their dimensions are 5'Lx3D'x24H so I could stack one more high before I'm outta room.Thanx for reading my novel!
-----
0.1.0 Burmese Python 12'

1.0.0 A-Mel Burmese Python 5.5'

1.0.0 A-Mel Granite Burmese Python 5.5'

1.0.0 Reticulated Python 7.5'

1.0.0 BCI 7.5'

0.1.0 BCI 5'

[ Show Entire Thread ]