Don't know the answer to the single male, multiple female thing.



For the incubator you have some options. First, Hovabator makes some inexpensive small incubators that can hold 2-3 clutches each or more depending on clutch size. So two Hovabators will satisfy your needs.



You can make your own incubator using a large cooler , some Flexwatt velcro'd to the inside, and a temperature controller. A Ranco or Johnson ON/OFF controller will suffice. Set to 80 deg F or so. I recommend the use of Reflectix insulation between the Flexwatt and the cooler wall. The low-wattage Flexwatt (6 watts/ft 3-inch wide) is a good choice for this application. So is heat rope. Make sure the cooler spout is open for air exchange. You can substitute a mylar-coated heat pad for the Flexwatt. Bean Farm sells those. Aluminum tape is great for adhering it, so is Velcro.



Colubrid eggs do not have to be incubated at a constant temperature. The temp can fluctuate a bit during the day. I've had eggs in a room (no incubator) that got into the low-mid 80's during the day and dropped into the low 70s and even high 60s at night. Eggs still hatched. Humidity is very important. The eggs shouldn't be too wet or too dry for too long. That part is easy. Some Hatchrite or perlite in a plastic shoebox, some monitoring and adjusting of moisture as needed and you are good.
-----
Mark

[ Show Entire Thread ]