I really need to rip a part of it apart. I get asked this a lot and a photo would explain it so easy.





I use 3" or 4" FW.



6" Aluminum flashing. Aluminum sheet metal that comes in a roll 6" wide.



And 6" fiberglass sill sealer. It's 1/4" thick and 6" wide in a roll.





NOW starting from the top and down:



1 layer flashing. Top Layer to protect the flexwatt.

1 layer Flewatt

1 layer Sill Sealer. It helps push heat upward.

1 layer flashing





I make a 4' long section of that. I use zip ties about every 6"-8" to hold all the layers together. The ties just go thru the edge of the flashing. NOT the flexwatt. Then zip tip it to the back of the shelf.





1 shelf I have lose. I would ot recomend that, but I like to move it where I need it.

--------------------------------------------------------------
-----
Thanks for reading.

Big Tom



www.HerpZillA.com

[ Hide Replies ]

• Breeding racks? And other questions.... - MimC85, Mon Oct 20 14:30:27 2008
• RE: Breeding racks? And other questions. - STEVES_KIKI, Mon Oct 20 15:04:29 2008
• RE: Breeding racks? And other questions. - MimC85, Mon Oct 20 15:15:30 2008
• racks - STEVES_KIKI, Mon Oct 20 15:48:01 2008
• RE: racks - MimC85, Mon Oct 20 15:58:29 2008
• RE: racks - STEVES_KIKI, Mon Oct 20 16:21:45 2008
• RE: racks - MimC85, Mon Oct 20 17:33:56 2008
• RE: racks - STEVES_KIKI, Mon Oct 20 20:52:14 2008
• RE: racks - HerpZillA, Mon Oct 20 16:23:54 2008
• RE: racks - MimC85, Mon Oct 20 17:31:42 2008
• RE: racks - HerpZillA, Mon Oct 20 18:06:37 2008