Hello,

If anyone has knowledge on building an incubator from an old wine fridge I have gutted the back pulled the freon lines and have stripped out the nuts and other parts from inside. I am sticking in the back 11 inch flex watt from the top to bottom. I am using a Spyder robotics therm. My question is where should I make the hole for my heat tape plug and the Thermostat wire? Also I am planning on drilling a hole big enough to stick the entire plug into the hole. Do I want to tape off the hole once threaded or do I need a little hole for air circulation. Also I am going to try and not use a fan. I will have plenty of time to monitor the temps. I am in a cool basement. Any other suggestions will be welcome and thank you in advance.

Best regards,
Bill

[ Hide Replies ]

• Building an incubator from a wine fridge - thunderpaws, Sun Jan 4 00:59:07 2009
• RE: Building an incubator from a wine fridge - joshhutto, Sun Jan 4 03:40:53 2009
• off topic - brianlovescheese, Sun Jan 4 09:59:36 2009
• RE: off topic - joshhutto, Mon Jan 5 01:38:25 2009
• RE: Building an incubator from a wine fridge - reedsdragons08, Sun Jan 4 03:55:48 2009
• RE: Building an incubator from a wine fridge - pitoon, Sun Jan 4 04:43:29 2009
• RE: Building an incubator from a wine fridge - ecdysis, Sun Jan 4 14:13:14 2009
• RE: Building an incubator from a wine fridge - ChadRamsey, Sun Jan 4 15:05:40 2009
• RE: Building an incubator from a wine fridge - ecdysis, Sun Jan 4 15:40:56 2009
• RE: Building an incubator from a wine fridge - ChadRamsey, Sun Jan 4 15:12:07 2009
• RE: Building an incubator from a wine fridge - thunderpaws, Sun Jan 4 23:58:16 2009
• RE: Building an incubator from a wine fridge - thunderpaws, Fri Jan 9 17:57:40 2009