mobile - desktop |
Available Now at RodentPro.com! |
News & Events:
|
[ Login ] [ User Prefs ] [ Search Forums ] [ Back to Main Page ] [ Back to Cage & Habitat Design ] |
Posted by: Omnivorous at Fri Mar 13 15:27:19 2009 [ Email Message ] [ Show All Posts by Omnivorous ] I am useing some IRIS MCBL tubs to make a small rack. Useing 4" flexwatt hooked up to a thermostat. I dont have a lot of tools and renting them for such a small project is too expensive. I wanted to know around what temps will the plastic start to melt. The reason I am asking is I cant make a recess for the flexwatt and the little plastic feet on the tubs might touch the heat tape depending on how i can make it. Also once I put in all the stuff the bottom of the tub might bow down a little and touch the tape so I just wanted to make sure it wont melt if it touches the tape. I try to run it at 88-90 degrees and have a backup thermostat set to 95 as an emergency backup. Would 95 degrees cause the plastic to melt? | ||
>> Next Message: RE: IRIS tub & sterilite tub melting points? - JMo, Fri Mar 13 16:18:38 2009 >> Next Message: RE: IRIS tub & sterilite tub melting points? - markg, Fri Mar 13 23:18:29 2009 |
AprilFirstBioEngineering | GunHobbyist.com | GunShowGuide.com | GunShows.mobi | GunBusinessGuide.com | club kingsnake | live stage magazine
|