Posted by:
Rconnelly
at Sat Nov 7 23:17:09 2009 [ Email Message ] [ Show All Posts by Rconnelly ]
Just making sure I get this correct. So you have about 1/2" added to the bottom of the tank on all 4 sides(front, back, and either side) and you are adding a groove into this in which you slide the heat tape into?
I have been staring at your last response for about an hour now so that I can try and understand it but it seems to have just gone over my head.
Is the heat tape just placed in the groove or merely set down on top of the cover/floor below it. Also, is it just wired and placed where it goes or is it placed in between something.
Sorry if this seems redundant, but I want to make sure I truly understand what your saying before I make an attempt.
Thanks again.
[ Hide Replies ]
|