Posted by:
wade
at Tue Dec 16 15:57:00 2003 [ Email Message ] [ Show All Posts by wade ]
I have done this and it works. Yes you have to drill a hole through the plastic part and then you stick the rivet through both the hardware cloth and the plastic. When you crimp the rivet with the tool it squeezes the pieces together.
Some things you need to do, you will need a washer on the rivet so the head of the rivet won't pull through the hardware cloth. You can buy the washers at the same place you get the rivets. When the rivet is pulled tight it will cause the plastic and the hardware cloth to buckle between the rivets sometimes. If instead of washers you use a strip of metal that is best of all. Drill through the metal strip the plastic and another metal strip so all the holes line up. Then insert the washer through the metal strip, the hardware cloth, the plastic, and finally through the second metal strip. That will give you a very strong attachment that looks nice too.
-----
Wade's Weptiles & Wodents
[ Hide Replies ]
- Pop rivet question - markg, Tue Dec 16 14:01:21 2003
 RE: Pop rivet question - wade, Tue Dec 16 15:57:00 2003
|
