Very good point to make and here is my take on this .



For heating wattages in cages it canbe a variable subject but as a "standard" heating wattage atleast with flexwatt that i use and that being 11" rated @ 20watts per foot.With all of my cages the "standard heat in flexwat is 1/3 - 1/2 the floor or back of cage heated which is depending on the animal in the cage. so a 3 ft cage would have 40 watts of heat installed and larger cage like a say 4-6 ft cage would have 40-60 watts of heat installed. With the type lighing i use this also will add to the heat that is inside the cage the 20 watt halogen lights provide a basking area in the cage under the light of about 80 degrees , this can vary depnding on the height of the cage from 12-24 " or higher of course the higher the cage the lower the basking area on the floor will be so a 3 ft cage could have the potential to produce 60 watts of heat and also maintain a basking area of 80 degrees /- depending on the height.





Weight of a product:



This is also something that will be posted atleast on my site and will be posted one each actual cage is builttoa finished product with glass doors installed, what i do right now is "estimate the weights" of the cages until a actual cage is built this can be close to with in /- 5-8 lbs as my actual 1/2" products vary between the HDPP & the HDPE with the HDPE being the heavier of the two products i use .

HDPP weighs #45lbs per 4x8 sheet

the two HDPE products weigh:

HDPE weighs #75lbs per 60"x96" sheet

so with that until actual cages are built the actual weight is estimated by my by the sq footage used in the assembly of the cage
-----
Buisnesses come and go everyday, what keeps you here is how you treated the customer the day before....

Check out the new website at www.junglehabitats.com and www.junglehabitats.com/forums/portal.php

[ Show Entire Thread ]