Hi



I would like to know if anyone have tried to use these for lighting purposes? I'm looking into putting lighting on the Polypropelyne rack that I'm planning to construct. The product is mostly used for computer lighting/accent but since I'm going to be using heat tape heating for my rack, heat provided by the lighht is not an issue since its supposed to not give out heat at all. I will only use this for lighting purposes. Other factors that I think is good is the lifespan of the light(30,000 hrs.) and that it has very low energy consumption. Would 30,000cd/m2 brightness bright enough for caging and racks? Do you guys think it's a good idea? Any hazardous effects from these lights on the reptiles?



Also, would a 1/2 polypropylene sheet be strong enough if cut in 20 x 40 sheets for the rack shelving? I'm worried that it will it sag if the pull of the box is on the longer side(40 in.) but the space in the room requires that design. I'm planning on using the Iris CB-110 underbed box for my large pituophis so I think that, weightwise, it would be around 40 lbs for each box with everything in it. Make note I also use paper pellets for these guys that is a heavier type of bedding(but works really well!) Will I need some supports on the long side of the sheet? I'm thinking those aluminum L-rods(is that the right term?) on the long ends. I will also be doing the rack in a ladder rack method to save on the weight. Btw, how is the polypropylene's weight compared to the same sized AB grade plywood? Any other cheaper suggestions on what type of plastic sheet I can use? I was quoted ~100.00/48x96 sheet and cut to needed size. Is that a good price?



Sorry for all the the questions but I hope you guys can help out. Thanks in advance.



Jonel
Cold Cathode Flourecent Light (CCFL) . . . . . LINK

[ Show Entire Thread ]