Hi Randy,



I like that simple design but there is some detail I cannot make out from the photo.



You say that is an all-in-one unit which I assume means the floor of an upper cage is the ceiling of the cage below, and so on, and so on.



Do you have one-piece sides and extend the horizontal panels inbetween or do you have multiple side pieces that span between the floors/ceilings?



From your picture it looks like the latter. If so, why? I assume the other way would be easier.



But I can barely make out that photo on my tiny laptop monitor.



>> ...and if the seams are sealed will not have any issues from moisture.(bci are the main animals I keep)



What is your source of melamine? I have bought several different grades over the years and found it to vary dramatically in moisture resistance and how it reacts to disinfectants.



Any more I just buy the cheap stuff and cover it with contact paper, but I'm always curious to hear what product people have used and how well it has held up.



>> ... I do not have the plastic along the back covering the peg board yet



I assume you mean a strip of plastic covering the lowest holes on the peg board, is that correct? What do you use for that?



Are you using plastic peg board?



>> ... or the heat tape installed in it yet)



Do you install this on the underside of each floor or to the floor itself?






-----
Current snakes:



1.1 Gonyosoma oxycephala - (Silver/Yellow)



3.4 Gonyosoma oxycephala - (Green)



2.1 Gonyosoma janseni - (Black)

[ Show Entire Thread ]