Posted by:
chris_harper2
at Thu Sep 30 11:51:38 2004 [ Email Message ] [ Show All Posts by chris_harper2 ]
Hi Randy,
I like that simple design but there is some detail I cannot make out from the photo.
You say that is an all-in-one unit which I assume means the floor of an upper cage is the ceiling of the cage below, and so on, and so on.
Do you have one-piece sides and extend the horizontal panels inbetween or do you have multiple side pieces that span between the floors/ceilings?
From your picture it looks like the latter. If so, why? I assume the other way would be easier.
But I can barely make out that photo on my tiny laptop monitor.
>> ...and if the seams are sealed will not have any issues from moisture.(bci are the main animals I keep)
What is your source of melamine? I have bought several different grades over the years and found it to vary dramatically in moisture resistance and how it reacts to disinfectants.
Any more I just buy the cheap stuff and cover it with contact paper, but I'm always curious to hear what product people have used and how well it has held up.
>> ... I do not have the plastic along the back covering the peg board yet
I assume you mean a strip of plastic covering the lowest holes on the peg board, is that correct? What do you use for that?
Are you using plastic peg board?
>> ... or the heat tape installed in it yet)
Do you install this on the underside of each floor or to the floor itself?
-----
Current snakes:
1.1 Gonyosoma oxycephala - (Silver/Yellow)
3.4 Gonyosoma oxycephala - (Green)
2.1 Gonyosoma janseni - (Black)
[ Hide Replies ]
|
Randy, some questions... - chris_harper2, Thu Sep 30 11:51:38 2004