I am making two 4 1/2'x1'x1' cages (basically two 20g long(standard) tanks end to end) out of 1/8th inch thick glass for two corn snakes. I was wondering where, if possible, I can get the molding (like on normal store bought cages) for these. I was also wondering how I should do a top, as the snakes are pretty strong and should have no problem pushing out of rubber banded screen. Is it possible to do a sliding screen for this type of cage? Maybe 2 screens? Any pointers and other help are greatly appreciated. Thanks!
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Custom Cages - Cage Molding
AndrewFromSoCal
Dec 25, 2006 06:44 PM
Replies (1)
bighurt
Dec 26, 2006 05:49 AM
Since your from SoCal check into US Plastics they have a website and are out of San Diego. They have a crap load of plastics to include some trimlast time I looked. They also build cstom acrylic aquariums last I checked. They built the Fish House Vera Cruz tanks.
Best of Luck
-----
Jeremy
"I am become death, the destroyer of worlds" July 16, 1945 Robert Oppenheimer
1.1 Double Het "Sharp" Snow RTB's
1.1 Hypomelenistic RTB's
0.2 Pastel Hypo RTB's
2.0 Double Het Stripe Albino RTB's
0.1 Suriname RTB
0.1 Anerthrystic RTB
0.0.10 Red Bearded Dragons
1.1 Rhinoceros Iguana's
1.0 Green Iguana
1.0 Ball Python
1.1 Cream Golden Retrieviers
1.0 Pomeriaian
0.2 Catus Terribilis
0.1 Spouse
1.0 Child
