Thanks for the suggestion on using a Uni-Bit to drill ventilation holes in plastic tubs. The method I was using was working ok, but the Uni-Bit method is far superior. Very fast, no cracking and no burrs. Thanks again. 
-----
Louis Kirkland
Cornerstone Reptiles
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Thank You To Brandon Osborne............
LKirkland
Oct 15, 2007 10:40 PM
Replies (2)
LKirkland
Oct 15, 2007 10:42 PM
It covers a range from 1/8" to 1/2"
-----
Louis Kirkland
Cornerstone Reptiles
joshhutto
Oct 15, 2007 11:46 PM
here's another couple of alternatives. use a straight soldering iron to burn the holes or switch to the new vision racks as they seem to provide the perfect amount of ventilation. I know we are slowly switching all of our racks around and couldn't be happier.
-----
Josh & Krysty Hutto
J&K Reptiles
Various Ball Pythons:::
1.0 striped vanilla
1.0 spider
1.2 Citrus Ghost and hets
1.2 Albino and hets
2.3 het Pied
0.6 50% poss het pied
1.1 Pastel (male has additional gene going on with him)
a bunch of normal female breeders
a bunch of normal female holdbacks and several rescued normal males
0.1 columbian boa, she's a feeding monster, controls my
over production of rats, lol
0.1 brazilian rainbow boa, another rat eating monster
1.1 corns
a BAD dog is MADE not bred, support the American Pit Bull Terrier as the greatest breed of dogs on Earth!!!!!
