can someone post some pics and directions how to install sliding doors and where to measure for the glass. i have a 1/4 inch track. the space is about 28x10.
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Help with sliding door installation
JeffK
Dec 20, 2007 02:26 PM
Replies (3)
Chris_Harper2
Dec 21, 2007 12:14 PM
Cut and install the glass with Liquid Nails. Hold it in place with masking tape while it cures. Deeper track on the top, shallow on the bottom.
Regarding what size to cut the glass, I believe it's usually 7/16" less than the rough opening, so about 9 & 9/16" in your case.
But cut some cardboard first to that size and make sure. I may remember wrong and you may have a slightly different product.
-----
Currently keeping a small collection of various Gonyosoma. Both G. janseni and G. oxycephala.
JeffK
Dec 21, 2007 12:26 PM
what is the easiest way to cut the track
Chris_Harper2
Dec 21, 2007 12:30 PM
Hacksaw, but I would not go out and buy one if you have something else to use. It's not hard to cut.
-----
Currently keeping a small collection of various Gonyosoma. Both G. janseni and G. oxycephala.
