Well I know everyone says use a soldering gun to poke their holes in the tubs. It is quite time consuming. I have found a solution for some that havent tried it yet. I use a Dremel with the biggest drill bit I could find. Put it on the fastest speed possible and boomp boomp poke them as fast as you can. I can usually put about a hundred holes in a boot box in less then a minute. It works quite well without cracking the tubs like a regular power drill. Give it a try it really does speed things up!!
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Good way to put holes in tubs
Lamiellm
Feb 14, 2008 10:56 AM
Replies (1)
PHLdyPayne
Feb 14, 2008 09:34 PM
Done this myself, it does work well though sometimes it melts the plastic and clogs the drill bits if you have it at too high a speed. I have no problems with a normal drill though it is a bit slower with a regular power drill. Push to hard and the plastic can crack.
-----
PHLdyPayne
