This is my first attempt at building my own rack. it is made from melamine, the sides had the holes pre drilled. It was a 8' piece that i had them cut in half at home depot. then i used 7 36" wide pieces as the shelves. Just waiting on the flexwatt and thermostat to arrive. Total spent was $250. $50 for the flexwatt and cables and clamps, $100 for thermostat (ranco prewired w/ 6 slot power supply) and $100 for the melamine. NOW...it does still have a slight wobble....any suggestions on how to fix that? BTW it holds 7 42 qt. tubs.
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
New Home Built Rack
ballmorphsbymike
Jun 01, 2008 09:21 PM
Replies (1)
Warren_Booth
Jun 01, 2008 09:38 PM
Use pegboard on the bck of the rack. This will strengthen the rack while still allowing airflow.
Warren
-----
Dr Warren Booth
North Carolina State University
Department of Entomology
3309 Gardner Hall
Raleigh, NC 27695-7613
