My ranco gives an E2 error if I set temp at 86 degrees or lower.
When it's over 86, there's no error message.
Why does this occur? Checked my manual, but can't find a clue.
Thanks,
Mike
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Ranco ??????????????
mingdurga
Oct 31, 2008 07:49 AM
Replies (2)
mingdurga
Oct 31, 2008 08:01 AM
The probe is sitting on one UT heater.
tmshaffer
Oct 31, 2008 10:32 AM
>>The probe is sitting on one UT heater.
Display
Messages To correct
E2
Appears if the control settings are not properly stored in memory. Check all settings and correct if necessary.
-----
www.hybridhaven.net
