HOW TO HEAT HISSER TANKS (FINAL VERSION)
Breeding tropical insects during wintertime need special attention especially temperature control of their tanks. In this article, I am writing the basic methods of heating tropical roach tanks. The methods described below can be used for variety of tropical roaches.
If you as an individual hobby roach breeder can maintain the room temperature consistently over 75F, then, you do not really need any extra heating mechanism for your Hissers’ tank. Just make sure that the night temperature in the tank does not goes down below 60F. (Here in Brooklyn, New York, the regulation of the Housing and Development Department of the New York City requires the landlord to provide heating for his tenants of house/apartment during the cold seasons. During the day, the room temperature has to be over 72F degree. Neverthless,the landlord was required to provide only over 55F degree during 10pm to 7am.)
Nevertheless, if you need to breed many Hissers (or any other smaller feeder roaches such as lobster roaches or B. Discoid roaches and etc.) to feed your reptiles consistently even during the winter time, you need extra heating mechanism to maintain the warmer temperature of their tanks. In this case, the temperature for Hissers’ tank should be upper 80F to lower 90F. Incidentally, the ideal breeding temperature for Hisser is 88F according to many professional breeders.
Their tanks could be heated up by several different heating mechanisms during winter in your room. Following is some of the heating mechanisms to keep your Hisser tanks nice and warm during the cold season to keep happy smiles on their small faces.
1. COMPUTER MONITOR
You may use your computer monitor as heater to warm up your 10-gallon Hisser tank. (LOL, seriously, folks.) Unfortunately, placing a tank directly on the top of the computer monitor makes the tank floor too hot for them. Even the thermometer hanging in the middle of the tank says 85F, the actual temperature of the tank floor could go over 95F. I found almost all the Hissers stayed on the top of the chick-water sponge and tree branches in my tank in such a setting. Therefore, I placed small cardboard boxes between the tank floor and the computer monitor to control the amount of heat received at the bottom of the tank. By adjusting the height of the box and area that receive the heat, I found that this actually worked very well.
I also realized that it is very important to heat only the half of the tank bottom. In this way, we are creating the tank floor with different temperatures. This allows Hissers to choose their favorite temperature zone. In reality, almost all the Hissers stayed at the “coolest” area of the tank in this setting.
(continue to PART 2)
modified from previous article posted on 20020208
All the rights reserved by Takeshi Yamada 2006
E-mail: niceguyinny123@aol.com




