Does this look like it would work? Its a very sturdy bed it was just to low and the matrances that fit it were not as sturdy so we got a new bunk bed but we have this pair left .. it looks a little beaten but its still stable
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Recycle Bed to Cage plans
qtkitty
Oct 13, 2003 10:27 PM
Replies (3)
qtkitty
Oct 14, 2003 10:24 PM
Should it work?.. NP
joels417
Oct 14, 2003 10:26 PM
Looks like it would work.
Where are the doors going to be?
What is the overall dimensions? Looks pretty good size.
What Kind of snake is going in here? What size?
>>Does this look like it would work? Its a very sturdy bed it was just to low and the matrances that fit it were not as sturdy so we got a new bunk bed but we have this pair left .. it looks a little beaten but its still stable
>>
-----
- Joel Smith
"If you're not part of the solution, you're still part of the problem"
qtkitty
Oct 15, 2003 06:45 PM
well the doors would be on that open side .. we dont have a snake yet .. but if we end up getting a burmese it would be for a burm.. and i would have to put planking on the bottom instead of plywood i think to hold the weight .. but if we get a Ball then it could be used for an Iguana cage and we could get a large fish tank or what not for the ball.. out Iguana is only 20inches so far
im trying to find a rescue "baby" of either a ball or burm because those are teh two snakes my fiance would like to get.
