I built this for my baby corns. I ran into a few design flaws along the way, but I like the way it turned out.
when I routered the dados I didn't get the spacing right, i.e. some draws are too tight and some too loose. Not much you can do about too tight. I thought a heat gun might relax the Sterlite a bit
I routed a recess for the heat tape and whould have made the slots from shelf to shelf on opposite sides, but I put all the slots down one side. I will now run one piece of tape for two shelves and have the ability to turn off a section.
The next one should have all the bugs worked out.