My ZooMed heat panel came off my terarrium glass, and it won't stick to it anymore. It is a little sticky, but the panel itself has become somewhat warped, thus not sticking. Any suggestions?
Please. My froggies need warmth!
Kathy
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
How can I get a ZooMed Heat Panel to Stick Again?
kathy5585
Jan 13, 2004 10:17 PM
Replies (2)
hugabunchaleos
Jan 14, 2004 12:20 PM
if you plan on never removing it, and has a temporary houseing for your froggies then i suggest unplugging the uth and letting it cool. then you can go to the hardware store and buy a small tube of silicone. It usually takes about 24 hours to cure and shouldnt be moved or heated until it is cured. let me know how it works out
-----
Brittany
LeoGeoKingdom
Have you hugged your Leo today 
reptilicus81
Jan 14, 2004 09:48 PM
you can always use electrical or duct tape...I've used it for years and my only problem was that I had to replace the tape from time to time!
-----
*Amy*
0.1 Green Iguana (yes, I have a lizard in my bathroom)-iggy
2.1 Ball Pythons (normal)-cosi, jake, and frosty
0.1 B.smithi (mexican redknee tarantula)-athena
0.0.1 midland painted turtle-nemo
1.1 dogs-rocky and skippy
1.0 normal grey cockatiel-opie
0.0.30 betta, guppies, rosy reds, fantail goldfish, clown pleco,...
