well guys here is some plans or soemthing like that.
materials as far as wood.
2-20x20 (sides)
2-20x38.5 (top and bottom)
1-38.5x18.5 (bottom)
1-3x40 (bottom lip)
for one big door.
2-2x40 (top and bottom of door frame)
2-17x20 (sides of door frame)
All of this you should be able to get from one 4x8 sheet of the wood fo your choice. assemble the top and bottom of the cage with the side to the outside, not the on the top and bottom of the side. then take the piece that is the back and place it inside the rectangle you just built. i do this for stability so you dont have to brace the cage. then add your bottom lip to the bottom outside of your rectangle. after all this is cut you can do what i do and get the left over wood cut into 2 inch strips for the frame for the door. you can either go with two doors or one big door that folds down. get plexi glass cut to the length you need to install it on the door. this is all out of my head so i dont know if it will work but i am trying it this weekend i will let you guys know how it goes and try and take some pics of assembly.
well if you guys think this will or wont work let me know. i think it will.
ken
-----
The next time the shuttle lands, lets all get dressed up in ape suits and charge at the astronaughts yelling and ranting. That way they can try to figure out where they took a wrong turn.
