What would I use to fill in the space (if any) between the boards to water seal them? Like an aquarium/silicon sealer, or something more for wood, like a caulk? Also, what would I use to fill in the gap left by screws so that I could sand it down flush and add a stain/finish to it?
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
More questions...
doubleok
Aug 07, 2004 12:00 AM
Replies (1)
froggystyle34
Aug 07, 2004 07:29 AM
what i do is counter sink screw holes by pre drilling everything, and then i fill them in either with a dowel rod or wood filler. for the seams i will use either aquarium grade silicon, or tub and tile caulk. then after a fw days drying time i will sand smoothly and paint then it looks like it is all one piece that was meant to be.
ken
-----
0.1 Albino Cal. King (Fokker)
1.0 Reverse Okeetee Corn (trouble)
0.1 Creamsicle Corn (Spot)
1.1 Bearded Dragons (Bob & Margret)
1.3 Dogs(George, Sandy, Cookie and Ladybird) they are rescues, Lhasa Apso, Mutt, Boxer, and Daschund mix
0.0.22 Bearded Dragon Eggs...more to come
1.0 Betta
0.1 Wife
0.1 Kid
