I know you're not supposed to trap heat, but if the heat can pass through the linoleum it's not trapped, right?
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Ultratherm heat pad between plywood and linoleum?
dmac
Aug 19, 2004 04:06 PM
Replies (2)
birddog5151
Aug 19, 2004 08:01 PM
heat from above with either a red heat source on a rheostat to adjust temps. If your room stays warm enough I would use an incandescent(white)bulb of appropriate size. Place it on a timer. Use Reeves(?) stacks to set up basking platform. These are thin plywood or paneling on 2x2's. Take a jigsaw and saw a hole 5 or 6 inches round in the middle and place a light source over the hole. Stack several of these and your snake can seek out the warmth it needs.
Mike B
dmac
Aug 20, 2004 06:17 PM
A
