n/p
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Bearded dragon cage that I recently finished
Chris P.
Nov 07, 2004 09:22 AM
Replies (4)
Chris P.
Nov 07, 2004 09:38 AM
n/p
hill4803
Nov 07, 2004 10:48 AM
Very nice!! What are the dims on this? I also think the background is one of the best I have seen...great job.
-----
www.hullabalooherps.com
harlanm
Nov 07, 2004 11:20 AM
very nice! is that paint or sand that is settled into the cravaces? its a subtle touch but makes all the difference.
it that carved foam, expanding foam, or did you use grout?
Chris P.
Nov 07, 2004 11:29 AM
The cage is approximately 4W x 3H x 2D. The rock was carved out of polystyrene. I filled gaps in the polystyrene with expandable foam in a can. I covered the polystyrene with sand colored tile grout. After the grout hardened for a couple days, I sealed it with a water based grout sealer. While the sealer was still wet, I put two different colors of sand on it. The plants are fake. After a couple of months with a sub adult BD in the cage it has held up pretty well. It can be tough to clean, and the pexiglass has gotten scratched up, but overall, it still looks pretty good.
