boa cage
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Somethings I have been working on, let me know what you think
kidsolo
Dec 11, 2004 04:35 PM
Replies (4)
kidsolo
Dec 11, 2004 04:36 PM
I have 6 almost done, I will show the room when I have it all done.
kidsolo
Dec 11, 2004 04:40 PM
5'x3' the two beems going across are for the lights, one will hold two heat bulbs and the other is for the UV.
tim5580
Dec 11, 2004 10:31 PM
The cages look nice and the table does too. Hope mine turns out half as nice when I try to make it. What did you use to hold that heat tape on there? Was it a piece of wood or some kind of sticky pad, or?
>>5'x3' the two beems going across are for the lights, one will hold two heat bulbs and the other is for the UV.
>>
-----
**********************************
Tim W.
jasonmattes
Dec 11, 2004 11:45 PM
Its a little late now but if you put a piece on top like you did for a litter dam on the bottom it will not sag as much..helps alot for strength. Also if you are going to stack them on top of eachother i would suggest putting a strip of wood on each end of the cage so that only the ends are sitting on the cage underneath it....if you know what i mean.....if you just stack them on top of eachother it will sag the top down on the cage beneath it.
Does the heat transfer through the wood?? i've never tried that before...i have always used heating pads or heat rope....inside the cage...
looks good...
