I JUST BUILT A HUGE WALL SYSTEM FOR ALL MY SNAKE AND I AM WONDERING IF I SHOULD BUT THE HEAT TAPE ON THE BACK WALLS OR ON THE FLOOR OF EACH TANK IT HOLDS 9 TANKS THAT AT 8'L 2' W 14" H
JUST NOT SURE THE BEST WAY TO PLACE THE HEAT TAPE CAUSE I WILL BE HOUSING MY SUPERS AND REG. RETICS AND GRANITE BURMS AND LAB BURMS JUST NOT SURE THE BEST WAY TO RUN THE TAPE CAN ANYONE HELP ME FOR THE BEST WAY TO RUN IT AND DOES ANYONE KNOW WHERE I CAN BUY THE TAPE WHOLESALE CAUSE I WILL BE BUYING 100' OF IT I WAS THINKING UF BUYING THE 11" TAPE OR SHOULD I BUY THE 4" SOMEONE PLEASE HELP
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
NEED HELP!!!
tattoistjake
Dec 27, 2004 12:05 AM
Replies (2)
jasonmattes
Dec 27, 2004 12:34 AM
I would put it on the floor...as far as size 4" sounds kinda small for retics and burms
justcage
Dec 27, 2004 10:35 PM
I agree, the tubs sound really big so you could go 11" underneath.. It would have to be covered with foil tape to protect ti from being torn when then tubs slide in and out.. Not to give a cheap plug but you can check out my site for some flexwatt info, Q & A and so forth... Hope this helps,
-Matt
-----
www.mgreptiles.com
CBB Herps and Heating Supplies
