My female is about to lay eggs in 2-3 weeks. This is the first ball python clutch I've ever had and the first time I've ever used a HovaBator. Can someone explain to me how to properly set it up to be successful? I set it all up last night but I can't seem to get the temp below 100 degrees. As soon as I turn it on, it goes right to and stays at 100. If I turn it down any further, it shuts off. I just want to make sure I'm ready when the eggs come. And I'm worried about making sure everything is right. ANY comments are appreciated for this subject more than any others before. Thanks alot. Ryan.
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Getting ready for first clutch, how do I set up my HovaBator?
RyanT
Mar 04, 2005 03:14 PM
Replies (3)
jmartin104
Mar 04, 2005 03:33 PM
Go to the Hovabator link. If you have any other questions, feel free to ask.
Hovabator Setup
-----
Jay A. Martin
jyohe
Mar 04, 2005 06:13 PM
plug it in........
set it on a stable table .........
turn it down one whole turn........
........
it turns on when temp drops to where it is NOW set to....
go from there........
use 3 thermometers to check each other........
.
ask about aspen bedding or thawing rats.......
-----
.................
BPMachine
Mar 04, 2005 08:52 PM
JY...Any word on the Albino??
