Hello, I was hoping I might get some ideas here. I was given these display cases by my Grandfather and thought they would make great snake cages. I sectioned them off for four cages and cut two large holes through the center wall of each cage. This makes them 5'2" x 18 x 13 each. Any ideas on heating it ? The cage is made out of a heavy particle board covered with maybe formica ? The back is just that thin board used on the back of most entertainment stands. Appreciate any help. Thanks
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Suggestions on heating cage ?
got2strum
May 23, 2005 06:52 PM
Replies (2)
justcage
May 23, 2005 11:01 PM
Awsome looking cages! I woudl probably have to say you will have to use a kane or Cobra UTH as they are the only ones that can be used inside the cage with no other work involved. You could use flexwatt and it woudl be cheaper but you would have to seal it off with plexi, sentra or even ceramic tile... shoot me an email if you want to chat about your heating. matt@mgreptiles.com
-----
www.MGReptiles.com
CBB Herps and Heating Supplies
GOLDSREPTILES
May 24, 2005 08:20 PM
You could also use radiant heat panels.
