Just to give an idea of a custom made cage. I didnt have any set plans, I just used my head. I work construction.
Rick
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
6' cage i built
pithons
Dec 05, 2005 02:39 PM
Replies (5)
markg
Dec 05, 2005 05:03 PM
I've always like the slant-front design.
twh
Dec 05, 2005 09:07 PM
excellent job,is that a melamine floor? what did you use to seal the plywood? glass or plastic on the doors? i also like the slant front design.have fun!
pithons
Dec 06, 2005 12:22 AM
Yes i used melamine for the floor wich worked well. its been 2 yrs since useing the cage and it hasnt peeled or warped. I think i used birtch plywood on the sides. with no sealer. and lexan plexiglass on the front doors. lexan plexi is the only plexi that dosnt crack or chip. i was able to drill through it and fasten it with nuts/botls.
deven
Dec 15, 2005 11:17 PM
not sure i like the top, not much ventilation or convection can occur. plus with the hinge you risk escape as the open area when you open it is more then with sliding doors. great concept though, we did that idea for some table top type displays, got the idea of EBV and folks liked it! easier to view!
great going though.
deven
Dec 16, 2005 01:01 AM
sorry, wrong photo...
