I was just wondering, If I get a rheostat can I plug it directly into the wall and plug my 6 outlet power strip into the rheostat? That way I would only have to buy one instead of 6....
-----
0.1 Snow Corn "Hope"
1.0 Ball Python "Wilson" (Castaway)
1. Orange Albino Black Ratsnake "Chunk" (Goonies)
.1 Orange Albino Black Ratsnake "Peaches"
0.0.1 Mexican Black Kingsnake "Onyx"
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Rheostat question
phiber_optikx
Dec 17, 2005 03:09 PM
Replies (4)
terrysxtreme
Dec 17, 2005 05:09 PM
That depends on the output of your heating elements,be careful not to overload your temp control,I have 4 hooked up to each temp controller and it does fine,Terry VNV 70-71
Cl0wn
Dec 17, 2005 06:26 PM
Be careful because that would be a huge fire hazard if not done properly. You would have to know the exact wattage your rheostat can take then figure out how much wattage each of your cords that your plugging into the power outlet would be. Personally I would just get a cheap dimmer switch for each of them instead of buying 6 rheostats.
dlcorn
Dec 18, 2005 07:21 PM
It would control everything on the power strip. It acts like a dimmer switch.
justcage
Dec 20, 2005 02:23 PM
How about buying a decent thermostat to regulate your heat sources and not ahve to worry about fire, overheating and dead animals... Just a thought...
-----
www.MGReptiles.com
