How many holes should I be putting into the iris containers and what is the best method to create the holes? any advice would be greatly appreciated.
thanks in advance
Reptile & Amphibian Forums
Welcome to kingsnake.com's message board system. Here you may share and discuss information with others about your favorite reptile and amphibian related topics such as care and feeding, caging requirements, permits and licenses, and more. Launched in 1997, the kingsnake.com message board system is one of the oldest and largest systems on the internet.
Ventilation for ball python tubs
SteveinIL
Dec 17, 2010 01:22 AM
Replies (3)
AdamNC
Dec 17, 2010 09:55 AM
I usually put about 12 or so on the front, and about 3-4 on each side.
Randall_Turner
Dec 17, 2010 12:50 PM
Best method for adding holes imo is to use a soldering iron. Makes clean holes without sharp edges. As far as the number of holes needed that depends on the type of rack (vision/FB etc do not need added holes, where as just about any others will be dependent on the humidity of your region.)
SteveinIL
Dec 17, 2010 11:54 PM
Thanks. I just ordered one of the iris racks from AP. Figured I'de get the tubs all cleaned, aired out and ready for when I bring my bp home from breeder.
