Posted by:
DMong
at Thu Dec 16 11:05:59 2010 [ Email Message ] [ Show All Posts by DMong ]
This really depends on many factors, but some things like that can be straightened out by clamping both ends of the cage down to a VERY solid flat surface, and forcing a precisely cut piece, or pieces of spacer wood strategically placed where they are needed to maintain the proper dimension. Sometimes if very gradual heat is applied to a given area while the spacer(s) are in place, the original shape can come back as it basically was before. Also, sometimes you have to OVER-space it slightly, so when the spacer shim is removed, the material doesn't tend to spring back a bit too far due to what is known as material "memory".
This can sometimes be very tricky. If you shim it and simply leave it that way for a very long period of time, the material will gradually be forced back just like it took a long period of time to be forced OUT of original shape(many months even), but if you use heat (such as a torch) over certain areas, and do it too quickly, it can also end up melting portions as well and not slowly heating the correct area that really needed it to relax the tension.
A large oven under a low heat would probably work well, but commercial/industrial ovens are probably the only types the cage will fit into.
Being a professional carpenter myself, there are several ways this can be done, but you have to really think about physics and the best ways to go about it.
Actually, leaving the cage out in the hot summer sun with spacers shims in the right area could even work. But being the dead of winter in most of the country, this wouldn't work too well now..LOL!. Also, as long as they were not placed too close, and allowed to heat things up very slowly, one or two strong heat bulbs placed in the right area(s) could also do the job. However, you must be VERY careful with whatever you do with heat, because you do not want to go doing other things and forget about heat lamps and have a fire hazard either..LOL!
I would use some good common sense and a TIMER so you don't forget about the heat lamps if you choose to do this, and check on the way the cage feels in the given area now and then, and you just might be able to pull this off successfully. When the shim material you forced into place starts feeling very loose, you know things are working well. Then simply let it cool very well before removing the shim(s), and BINGO!......done deal!
Good luck!
~Doug ----- "a snake in the grass is a GOOD thing"
my website -serpentinespecialties.webs.com
[ Hide Replies ]
|