Well so it begins. This is how it starts, just to get this far it took me three days LOL. I am already killing trees and I haven't even bought the wood yet. I like putting the vision cages in cabinets it just makes them look better. I use 2- 1/4 bolts in the back of each cage with wing nuts to hold them in place. I raise the cages up one inch, so the heat pads can get some air. the back is opened about 2 inches at the bottom of each cage so the wiring for the heat and lights. I use one 12 inch fluorescent light for each cage. the light is just enough for a little lite. I use 3/4 plywood with one side finished. This will be very heavy but! it sure as hell won't tip over LOL. I stain it and varnish it and leave it outside for about a week before I move it into the house and then a few days more before I move snakes in it. I just thought you guys might like to see how I get crazy sometimes. But I have a hell of a good time doing it. And a picture of one of my Fl. Kings.

Thank-you for your time






-----
Tom S

1.1 Flame Lampropeltis getla Floridana

1.0 Hypomelanistic Lampropeltis getula Floridana

0.1 Axanthic Lampropeltis getula Floridana

1.1 High Yellow Lampropeltis getula Floridana

0.1 Hypomelanistic Lampropeltis triangulum hondurensis

1.0 Anerythristic Lampropeltis triangulum hondurensis

1.2 Tangerine Lampropeltis triangulum hondurensis het albino

[ Hide Replies ]

• The start of new project for my snakes - bigtman, Wed Sep 28 00:46:14 2011
• RE: The start of new project for my snakes - DISCERN, Wed Sep 28 01:07:55 2011